ViaSat 3862, Руководство по эксплуатации и обслуживанию, Страница: 71 / 173

Chapter 3 - Operation
g) Press RCVR03 to select receiver3 for input. Enter in dB the signal
strength sufficient to enable tracking.
h) Press NEXT to display softkeys for receivers 4 through 6.
i) Press RCVR04 to select receiver 4 for input. Enter in dB the signal
strength sufficient to enable tracking.
j) Press RCVR05 to select receiver 5 for input. Enter in dB the signal
strength sufficient to enable tracking.
k) Press RCVR06 to select receiver 6 for input. Enter in dB the signal
strength sufficient to enable tracking.
l) Press RCVR07 to select receiver 7 for input. Enter in dB the signal
strength sufficient to enable tracking.
3.3.16.5 Digital Controller Setup Configuration Store/recall
Refer to Figure 3.15. These softkeys store and recall digital controller
configurations. The stored parameters are listed below.
1. Setup parameters
•
Scan amplitude
•
Scan rate
•
Scan mode
•
Filter selection
•
Secondary mode selection
•
Rate limit
•
Torque bias amount and status
2. Control parameters
•
Scan code generator mode (fixed, swept, etc.)
•
Fixed scan code generator frequency
•
Autotrack acquisition threshold for all seven channels (if installed)
•
Autotrack receiver channel selection (if installed)
•
Steptrack stepsize (if installed)
•
Steptrack beamwidth (if installed)
3862 Autotrack Controller
3-26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com