Vetus DBPPJA, Руководство по установке

Страница: 13 / 64

020813.11
13
vetus®
Installation manual DBPPJA - Proportional panel for bow and stern thruster
ENGLISH
4 .6 Configuring thrust direction
Carry out the following actions on one panel in the order indica-
ted:
1 Place the panel in configuration mode
• Press and hold the "ON / OFF" button for 10 seconds.
2. Press the On/Off button
twice.
2 x
1 BLUE, flashing
2 RED, flashing
4 RED, flashing
2
4
1
didahdi ( . − . )
During the first 6 seconds, LED (1) flashes blue and the buzzer will
continuously signal a didididididi ..... (. . . .). Keep pressing the "ON /
OFF" button. After 10 seconds the buzzer sounds the signal didididi-
dah (. . . - -).
2 3
1
i
mportant
If another combination of LEDs
is lit, first restore the factory
settings (see 4 .5) and start chec-
king the thrust direction again
(see 4 .4) .
10 seconds
seconds
Configuration mode
seconds
(1) BLUE, flashing
6
dididididididid ( . . . . . . ) dididididah ( . . . . − )
4
3
2
4
5
1
ON/OFF
3. LEDs (1) (blue) (2) (red) and (4) (red) flash and you hear the signal, di-dah-di (. -.)
Now the panel is in configuration mode.
1 x
1 BLUE, flashing
3 RED, flashing
4 GREEN, flashing
3
4
1
1 BLUE, flashing
2 RED, flashing
5 GREEN, flashing
5
1
2
4. Configuring thrust
direction for a
bow thruster:
Move the joystick to the
upper left corner and
back until LEDs (1) (blue),
(3) (red) and (4) (green)
flash.
Repeat if necessary.
6. Press the "ON / OFF"
button once to confirm
the setting.
4
5
6
5.
Configuring thrust
direction for a
stern thruster:
Move the joystick to the
bottom left corner and
back until LEDs (1) (blue),
(2) (red) and (5) (green)
flash.
Repeat if necessary.
OR
OR
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the "ON / OFF" button once to switch the
panel to the OFF position, see 4.3, and wait 5 seconds before turning
the panel back on).