MAGNET AND SENSOR INSTALLATION
Sensor Diagram
We recommend that you install your V-50 in the following manner, starting with the
sensor unit on the fork and working up to the mounting bracket on the handlebar.
STEP 1
Mount the Vetta universal sensor loosely (so that you can slide it around) to the
fork blade using the zip-tie provided. The sensor can be mounted at any point
along the fork. However, we recommend a position on the back side near the top
of the left fork blade. This position will help protect the sensor from being hit by
rocks, tree branches and other objects.
STEP 2
Again, loosely attach the sensor magnet to one of the spokes on the left side of the
front wheel. Adjust the magnet and sensor positions by sliding both pieces around
until you get the sensor as high on the fork blade as possible while still
maintaining the necessary magnet-to-sensor spacing (1-2mm).
NOTE:
The magnet should pass within 1-2mm of the sensor, and the top of the
magnet should be no higher than the top of the small arrow molded into the face of
the sensor.
