User Instructions for
VIP- 802-KMV8 Series "MegaSwitch"
Keyboard, Mouse and Video Switch
FEDERAL COMMUNICATIONS COMMISSION
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
CE
This equipment has been tested and found to conform to the directives and standards for a Class A Information Technology
Equipment type and for the Commercial Light Industrial equipment class.
INTRODUCTION
The VIP-802-KMV8 "MegaSwitch"
Keyboard, Mouse and Video Switches are available as a full function, Integrated Switch
with keyboard control selection, switching keyboard, mouse, and video. The "MegaSwitch" allows one Workstation comprised
of a PC Keyboard, a PS/2 Mouse, and up to eight VGA Monitors to control and work with one or two PC's.
The "MegaSwitch" system consists of the following components:
1. One - Switch Unit;
2. One – VIP-210 Power Supply.
Note: The "MegaSwitch does not come with keyboard, mouse, or VGA extension cables.
They may be ordered
from Vetra separately.
INSTALLATION
There are three main steps to connect the Switch:
1. Connect PC's to Switch unit:
a)
Connect the keyboard inputs of the PC's to the Switch using 6 pin PS/2 male/male extension cables. Connect PC#1's
keyboard port to the backpanel connector of the Switch marked "PC1 KBD". Connect PC#2's keyboard port to the backpanel
connector of the Switch marked "PC2 KBD".
b)
Connect the mouse inputs of the PC's to the Switch using 6 pin PS/2 male/male extension cables. Connect PC#1's mouse
port to the backpanel connector of the Switch marked "PC1 MSE". Connect PC#2's mouse port to the backpanel connector of
the Switch marked "PC2 MSE".
c)
Connect PC#1’s Monitor A video output to the backpanel connector of the Switch marked “TO PC1 MON A” and connect
PC#2’s Monitor A video output to the backpanel connector of the Switch marked “TO PC2 MON A”. Repeat this step for PC’s
#1, and #2 for all remaining video outputs B thru H.
2. Connect a Workstation to the Switch:
a)
Connect the keyboard to the 6-pin DIN connector on the rear panel of the Switch marked "KBD IN".
275 Marcus Blvd Ste-J Hauppauge, NY 11788-2022 USA
Tel: 631-434-3185 Fax: 631-434-3516
www.vetra.com email: [email protected]
