background image

10

SAFETY LABEL IDENTIFICATION

Product safety signs or labels should be periodically inspected and cleaned by the product users as necessary to
maintain good legibility for safe viewing distance — ANSI 535.4 (10.21).  Contact the manufacturer for replacement
labels.

VESTIL

MANUFACTURING

CORPORATION

Phone: (260) 665-7586 • Fax: (260) 665-1339

E-mail: [email protected] • www.vestil.com

BOOM CAPACITY CHART WTJ-20-4 (AC OR DC)

4 FT

2000 LBS

1850 LBS

1500 LBS

5 FT

2000 LBS

1450 LBS

1200 LBS

6 FT

1900 LBS

1250 LBS

1000 LBS

7 FT

1800 LBS

1050 LBS

850 LBS

BOOM EXTENSION

DEGREE

OF LIFT

60°

40°

20°

BOTH SIDES

577

2

3

VESTIL MANUFACTURING

CORPORATION

Phone: (260) 665-7586 • Fax: (260) 665-1339 • E-mail: [email protected] • www.vestil.com

585

586

CLEAR  BACKGROUND WITH YELLOW TEXT

VESTIL MANUFACTURING CORPORATION

[email protected] • www.vestil.com

287

REV 09/03

MODEL/MODÉLO/MODÈLE ____________

CAPACITY _______________________ lbs.

CAPACIDAD/CAPACITÉ ____________ kgs.

SERIAL/SERIE/SÉRIE _________________

SIDE WITH CRANK

287

VOLTAGE LABEL

HOLE IDENTIFICATION,

BOTH SIDES

Tighten know before moving vehicle.

Apriete la perilla antes de vehiculo móvil.

Resserrer le bouton avant de déplacer véhicule.

IN HOUSE LABEL

DO NOT exceed rated capacity

LOWER LOAD before moving to avoid

load swing

NEVER STAND under, beside or in front
of load

USE on hard level surface

INSPECT connections before using

READ manual before use

WARNING

ADVERTENCIA

AVERTISSEMENT

No exceda la capacidad tasada

Descienda la carga antes de mover para
evitar que la carga se balancee

Nunca se situe debajo, al lado o delante
de la carga

Use en una superficie a nivel dura

Inspeccione las conexiones antes del uso

Lea el manual antes del uso

NE PAS DÉPASSER la capacité nominale

DESCENDRE la charge avant de la
transporter pour éviter la giration

JAMAIS vous mettre sous, à côté de ou
devant une charge

UTILISER sur un sol plat et dur

INSPECTER les connexions avant utilisation

LIRE le guide avant utilisation

VESTIL MANUFACTURING CORPORATION

 • Angola, IN USA • Ph. (260) 665-7586 • Fax (260) 665-1339 • www.vestil.com

586

!

!

!

586

BOTH SIDES

1

1

4

5

2

3

1

4

6

5

6

WTJ

VAN-J

Содержание VAN-J Series











Отзывы: