Rev. 5.7.2019
TCD MANUAL
Copyright 2019 Vestil Manufacturing Co.
Page 15 of 20
Using the trash can dumper
NOTE: Only use TCD-M dumpers with Vestil model TH-32, TH-64, and TH-95 trash bins.
Step 1: Move the trash can dumper (TCD) next to the dumpster or other large trash receptacle. Move the TCD by
grasping the handles and pushing it in the intended direction. Position the TCD as shown in the diagram and apply
both floor locks. Floor locks are surrounded by a red dotted square in the diagram.
Handle
Step 2: [TCD-M units] Configure the wheel cradles for the trash bin that will be used with the dumper. Attach the wheel
cradles to the mounting plate as shown in the appropriate diagram.
Step 3 [TCD-U units only]: Push your trash bin into the chute. The
front of the bin should rest against the back of the chute. Open the
lid. Slide the bin retainers along the retainer rails into firm contact
with the top of the bin. To slide a retainer down a rail, simply press
on the retainer. To slide a retainer up a rail, release the clamp and
then move the retainer.
Step 3 [TCD-M units only]: Push the trash bin between the wheel
cradles. Wheels will fit between the cradle brackets and the bottom
flanges of the cradles. See step 2.
Step 4:
Stand to the side of the dumper
. Raise/tilt the chute by
pressing the UP button on the hand control (see p. 9). Press the
button until the power unit stops. The power unit stops when the
chute is fully tilted. When the trash bin is empty, lower the chute by
pressing the DOWN button on the hand control. The power unit will
automatically stop when the chute is completely lowered.
Front view
Cradle mounting plate
Cradle mounting plate attachment diagram (trash bin
model appears to the left of the corresponding diagram)
Right wheel cradle
34-516-009
Left wheel cradle
34-516-008
TH-95
TH-64
TH-32
Cradle bracket
Front
Back
Bottom flange
Press down to
release clamp
Slide retainer up
or down rail
Dumpster
Floor lock
Press
down
to
apply
lock
Press
down to
release
lock
Floor lock
Retainer
Chute
TCD-U
