Vestil SWA-48, Инструкция по эксплуатации

Страница: 6 / 17

Table of Contents 9/9/2021 SWA-48-PMO MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Corp.; All rights reserved Page 6 of 17
Operation:
• Keep all personnel clear of the machine when it is in operation. Be certain no part of any person,
fork truck, or other object is in the path of the rotating load before rotating the turntable.
• Do not stand or sit on the turntable or its load at any time.
• Keep all body parts and clothing away from the machine’s drive system(s).
Do not use the stretch-wrap machine if any damage or unusual noise is observed, if it is in need
of repairs, or if it seems to be malfunctioning. Notify your supervisor or maintenance personnel if
you notice anything out of the ordinary.
The standard stretch-wrap machine is furnished with a constant-pressure (dead-man style) foot switch control. Pressing
the foot switch will turn on the motor to rotate the turntable. The turntable will rotate only while the control is pressed.
Upon releasing the control, the turntable will coast to a stop.
The turntable speed can be adjusted with the speed control knob on the front of the motor speed control. The display on
the front of the motor controller shows the approximate RPM of the turntable. Turn the speed control knob clockwise to
increase the turntable speed, and counterclockwise to decrease the speed.
Pull the handle upward to move the stretch-wrap material roll upward. Push the handle down to move the material
downward. Control of the tension/stretch of the stretch-wrap material is achieved by turning the handle on top of the
material.
Screw the handle clockwise, downward, to increase the material tension and stretch, and turn it counterclockwise, upward,
to decrease the material stretch.
Always carefully watch the palletized load while the turntable is rotating.
Set the material tensioner so the material will pull off the roll easily. Pull stretch-wrap material off the roll and either hold or
tie it to the load to be wrapped. Press the foot switch to rotate the load.
After one or two overlaps, tension the material to the desired stretch rate. Raise and lower the material carriage until the
load is covered 100%, with two or three overlaps. While the turntable is still rotating, the material can either be cut with a
knife or torn with the hands. Press and smooth the cut end of the material up against the side of the load.
Note: Best results for palletized loads are generally achieved by having the wrap overlap the sides of the pallet at the
bottom and extending slightly above the load at the top. Ensure that all safety and warning labels stay in place and are
legible. Refer to the Labeling Diagram on p. 12.
Changing Delta Motor Speed Controller Parameters:
Press to switch to the program mode.
a) The following screen, , will appear.
This indicates the specific parameter group.
b) Use the buttons, shown on the next page, to change all parameter settings.
Prog
Data
0-