Vestil STRAP-FP, Инструкция по эксплуатации

Страница: 7 / 8

TABLE OF CONTENTS Rev. 6/1/2021 STRAP-FP MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Corp Page 7 of 8
Confirm that cotter pins are in place and in good condition.
3.
Spool dispensing assembly: Examine the inner and outer retaining discs, the wing nut, the threaded
rod, the rod coupler and set screw, and the rod extension. Make sure that the wing nut threads
smoothly and easily onto the threaded rod and the rod extension. Confirm that the rod and
extension are both straight and that the threads are undamaged. Inspect the retaining discs for
warps and cracks. Examine the guide wheel assembly (roller bracket, upper and lower rollers, spring,
washers, roller pin, and cotter pins) for damage, missing, worn, or loose parts. Inspect the). Replace all
parts that are damaged.
LABELING DIAGRAM
L
abel content and location are subject to change so your product might not be labeled exactly as
shown. Compare the diagram below to your RECORD OF SATUSFACTORY CONDITION . If differences
between actual labeling and this diagram exist, contact TECHNICAL SERVICE . Replace all labels that
are damaged, missing, or not easily readable (e.g. faded). To order replacement labels, or to inquire
whether your unit is properly labeled, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm or by calling (260) 665-7586 and asking for the Parts
Department.
B (on side of tool tray): Label 1153
C (on back of tool tray): Label 218
A (on back of tool tray): Label 1049
B
A
C
D (on front of tool tray): Label 1000
E (on front of tool tray): Label 675
D
E