Rev. 9/11/2019
POW-CAR-50 MANUAL
Copyright 2019 Vestil Manufacturing Corp.
Page 8 of 13
INSTALLATION AND ASSEMBLY
The turntable must be securely anchored to the floor before being put into service.
1. Move the machine to the installation site. Install the machine only on an even, level surface.
2. Fasten the machine to the floor with anchor bolts. There are 2 anchoring tabs located close to the power unit.
There are 2 more tabs along the circular frame that are hidden by the tabletop. To access these tabs, rotate
the tabletop to align the Access Hole with each tab. All anchoring tabs have holes for anchor bolts. Your
building engineer should evaluate the installation site and select
3
/
8
in. anchor bolts of appropriate length for
the location. Install the anchor bolts.
3. Shim and grout under the frame as necessary to level the turntable.
4. Plug the power unit into an AC power source that
matches the voltage of your motor.
5. Test the powered functions:
a. Turntable rotation: press the foot pedal to
initiate rotation. The turntable will rotate as
long as the pedal is pressed.
b. Delta speed controller: refer to the Delta
operation manual. The dial in the lower left
corner of the display panel controls turntable
rotation speed. Turn the dial clockwise to
increase speed and counterclockwise to
reduce speed.
After installing the turntable, increase rotation speed to maximum. The number displayed on the
screen of the control is the approximate number of revolutions per minute. Make note of the maximum
Record of Satisfactory Condition
. Reset the speed to minimum when you
are finished.
Access
hole
Anchoring
tab
Anchoring
tab
Foot
pedal
(inside
yellow
guard)
Power cord
Motor
speed
controller
Anchoring
tab
Anchoring
tab
[Model POW-CAR-AR5
shown in photo]
