10
Section 10: ASSEMBLY AND SET-UP
10.1 Platter
assembly
1. Insert platter to center spindle
2. Put platter weight on platter
3. Put silicone mat on top of platter weight.
Caution: make sure silicone mat is dust-free
4. Remove the protective sheet of blank disc on both sides, and place blank disc on silicone mat; push the
blank disc down on silicone mat using a lint-free cloth or the included record cleaner. Apply sufficient
pressure to firmly secure the vinyl blank to the silicone mat.
5. Screw disc holder and secure blank.
x
If the blank disc is not dust-free, it may create skipping or noise problems. Ensure your blank is
perfectly clean.
x
If the blank disc is not secured to silicone mat, slipping may occur which will render your final
cut unusable.
10.2
Ioniser Assembly
Secure ioniser with 2 screws as per picture below.
(Figure 10.2-A)
FIG10.2‑A
10.3
Tracking arm/counter weight assembly
Assemble counter weight on the rear of tracking arm.
(Figure 10.3-A)
FIG10.3-A
Disc holder
Blank vinyl disc
Silicone mat
Platter weights
Platter
Center spindle
