VESPA 633844 IT, Руководство по обслуживанию

Страница: 246 / 308

System bleed
- Start up the engine until the operating tempera-
ture is reached.
- Remove the rubber hood over the bleed valve
- Obtain a rubber tube that is of the right length to
connect the valve to the expansion tank
- Place one end of the pipe on the bleed valve and
the other in the expansion tank
- Loosen the screw by two turns until the commu-
nication hole is revealed with the head as shown
in the photo
- Wait until only coolant comes out of the rubber
pipe so as to eliminate any air bubbles inside the
circuit.
- Tighten the bleed valve respecting the maximum
torque.
- Bring the coolant up to the correct level inside the
expansion tank
Locking torques (N*m)
Bleed screw: 3
Check
1) Look to see that the thermostat is not damaged.
2) Fill a metal container with approx. 1 litre of wa-
ter.
Immerse the thermostat, and keep it in the centre
of the container.
Immerse the multimeter temperature probe, and
keep it close to the thermostat.
Heat up the container using the thermal gun.
Check the temperature when the thermostat starts
to open:
Heat up until the thermostat is completely open.
3) Replace the thermostat if it is not working prop-
erly.
CAUTION
Cooling system
Vespa GTV 250 i.e.
COOL SYS - 2