Vertiv NetSure PSS12/2000-19B, Инструкция по установке и эксплуатации

Страница: 41 / 44

Vertiv
| NetXtend +12 VDC Bulk Output Power System Installation and User Manual (UM588706000) | Rev. H
39
OPERATING PROCEDURES
SCC Controller, Rectifier Module, and BBU Module
For operation instructions on these units, refer to the following documents.
•
SCC Controller Instructions (UM1M520HNA)
•
Rectifier Module Instructions (UM1R123000)
•
BBU Module Instructions (UM1B123000)
Use of the Rectifier Current Limit
In a system with both rectifiers and BBU’s, you can set a current limit for the rectifiers in the system via the
controller. When the load exceeds this current limit, the BBU’s will provide power as needed.
Expected Number of Rectifiers and BBU’s
You can set the number of rectifiers and BBU’s expected to be in the system via the controller. If the controller does
not find the specified number of rectifiers or BBU’s, the controller will send an SNMP trap to notify the RMS.
Detailed Status for Rectifiers and BBU’s
When a yellow or red LED is illuminated on a rectifier or BBU, the SNMP data from the controller can be used to
identify the specific problem.
Local Indicators
SCC Controller, Rectifier Module, and BBU Module
Refer to the separate instruction documents for descriptions of the local indicators located on these units.