Vertiv NetSure 502NGFB Series, Руководство по установке

Страница: 46 / 86

Vertiv
| NetSure 502NGFB Installation Manual (Section 6009) | Rev. Z 46
Installing and Connecting Batteries in an Optional Battery Tray (If Furnished)
Important Safety Instructions
ALERT! Correct polarity must be observed when connecting battery leads.
WARNING! Special safety precautions are required for procedures involving handling, installing, and
servicing batteries. Observe all battery safety precautions in this manual and in the battery instruction
manual. These precautions should be followed implicitly at all times.
WARNING! A battery can present a risk of electrical shock and high short circuit current. Servicing of
batteries should be performed or supervised only by properly trained and qualified personnel
knowledgeable about batteries and the required precautions.
The following precautions should be observed when working on batteries:
•
Remove watches, rings, and other metal objects.
•
Eye protection should be worn to prevent injury from accidental electrical arcs.
•
Use certified and well maintained insulated tools. Use double insulated tools appropriately rated for
the work to be performed. Ensure that wrenches with more than one working end have only one
end exposed.
•
Do not lay tools or metal parts on top of batteries.
•
Disconnect charging source prior to connecting or disconnecting battery terminals.
•
Risk of explosion if battery is replaced with an incorrect type or if polarity is reversed. When
replacing batteries, replace with the same manufacturer and type, or equivalent.
•
Dispose of used batteries according to the instructions provided with the batteries. Do not dispose
of batteries in a fire. They may explode.
•
ALWAYS FOLLOW THE BATTERY MANUFACTURER’S RECOMMENDATIONS AND SAFETY
INSTRUCTIONS.
In addition to the hazard of electric shock, gas produced by batteries can be explosive and sulfuric acid
can cause severe burns. Do not open or mutilate batteries. Released electrolyte is harmful to the skin
and eyes, and is toxic. If electrolyte comes into contact with skin, the affected area should be washed
immediately with large amounts of water.
DANGER! This equipment may be used in conjunction with lead-acid batteries.
Working near lead-acid batteries is dangerous!
•
Batteries contain sulfuric acid.
•
Batteries generate explosive gases during normal operation. Systems containing batteries
should never be installed in an airtight room or space. Only install in a ventilated environment.
•
Batteries are an energy source that can produce high amounts of electrical current.
•
FOR THESE REASONS, IT IS OF CRITICAL IMPORTANCE THAT YOU READ THESE
INSTRUCTIONS AND FOLLOW THEM EXACTLY.
•
WHEN WORKING WITH LEAD-ACID BATTERIES:
•
Wear complete protection for eyes, face, hands, and clothing. Examples are safety goggles or
face shield, a rubber apron and gloves.
•
If battery acid enters your eye, immediately flush your eye with running cold water for at least 15
minutes. Get medical attention immediately.
•
If battery acid contacts skin or clothing, wash immediately with soap and water.