Vertiv Liqui-tect LP6000, Инструкция по установке и эксплуатации, Страница: 47 / 82

5.3.12 SNMP/Syslog Configuration
The SNMP/Syslog page configures SNMP communication including SNMP traps. The page also allows
testing the traps, refer to the following:
• Sending a Leak-detection Test Trap on page 48
• Sending a Cable-break Test Trap on page 48
• Sending a Contamination Test Trap on page 48
FIELD DESCRIPTION
System Name Name of the system. Displays below the menu bar and is included in e-mail notifications. 30-character limit.
System Contact
Indicates person responsible for the Liqui-tect system. Only available through SNMP Gets. Not included in e-mail
or SNMP Trap notifications. 30-character limit.
System Location Physical location of the Liqui-tect system. Not included in e-mail or SNMP Trap notifications.
Table 7.12 MIB-2 System options
FIELD DESCRIPTION
Get/Read Community for get/read access.
Set/Write Community for set/write access.
Trap Community for trap access.
Table 7.13 V1/V2C Community Names options
FIELD DESCRIPTION
Select SNMP Trap Type
Selects the version of SNMP trap to use.
•
V1-Trap
•
V2C-Trap
•
V2C-Inform
Max Inform Retries Number of re-send attempts for un-delivered traps. Zero (0) allows unlimited attempts.
Inform Interval Length of time between re-send attempts.
Modbus Zone Traps Enables disables Modbus zone traps.
Table 7.14 Traps options
FIELD DESCRIPTION
IP Address
IP address of the receiving device. All zeros (0.0.0.0) enables any device to access LP6000 through an MIB
broswer.
TrapEnable Enables/Disables if device will receive traps.
Syslog Message Enables/Disabes if device will receive system log messages.
Table 7.15 Trap Destinations options
Vertiv | Liqui-tect LP6000 Installer/User Guide | 47