SNMPv1/v2c Access Folder
This page contains settings for network hosts that access data using SNMPv1/v2c. Up to 20 access hosts
can be enabled and configured. Port 161 is required as the default SNMP trap port to receive alarms. Like
the SNMPv3 pages, the setting for each host may be reached by clicking the links in the data portion of
the page or by clicking the folders for the access hosts. Also, data shown in the table may be changed by
clicking the link above the table.
SNMPv1/v2c Access Settings
SNMP Access IP Address
Configure network hosts interested in device information access. The host can be identified as
either an IP address or the host’s network name
SNMP Access Type
SNMPv1/v2C access type: Read Only or Read/Write
SNMP Access Community String
String identifying a 'secret' to allow read-only or write-only access. The default is read-only acciess:
public (case-sensitive). Write-only access: private (case-sensitive).
6.5.4 YDN23 Folder
The YDN23 protocol supported is based on the YD-T-1363 specification using an RS-485 network
connection.
YDN23 Protocol settings
Managed Device Write Access
Enable or Disable the YDN23 server to write to the managed device.
Device Address
YDN23 device address
Baud Rate
The communications rate in bps.
6.6 Status Folder
The Status folder contains no configurable items. It displays the System Status of the Unity card and a list
of events that affect the card’s status. Status is also indicated by the icons next to the items. See
on page 23 for a description of the icons.
6 Editing the Unity Card Configuration
59
