Vertiv Liebert iCOM DP400/500, Инструкция по установке и эксплуатации

Страница: 92 / 180

Device X
Editable field to describe the device.
SysType
Read-only, The type of feedback from the power meter. Valid values:
• 0: 3Ph+N
• 1: 1Ph+N
• 2: 2Ph+N
• 3: 3Ph
Type
Read-only. The type of power meter.
9.2 Fluid Temperature Monitoring
Up to two supply and two return sensors may be connected to each cooling unit to monitor local and remote fluid
temperature differential. A 2T sensor monitors fluid temperature (two 2T sensors on dual circuit units).
1. Touch , then > Auxiliary Device Setup > Sensors > Fluid Sensors > Fluid 2T Sensor . The SENSOR
PROPERTIES panel opens.
2. Adjust the temperature offset, and touch Save . The fluid temperature sensor settings are saved.
NOTE: Depending on the type of thermal management unit, included components, and control settings of your
system, all of the options listed may not be available on your iCOM display.
9.2.1 Fluid Sensor Options
Current Fluid Temperature
Actual temperature reading.
Fluid Sensor Type
Type of sensor connected. Options are:
• 2T
• Dual 2T
Fluid Temperature Offset
Correction (calibration) value added to the fluid temperature reading. Used in the event that the fluid temperature
sensor readings are incorrect.
• May be a positive or negative value.
9.3 Configuring Analog Input Devices
1. Touch , then > Auxiliary Device Setup > Analog Input .
The ANALOG INPUTS and ANALOG INPUT PROPERTIES panels open.
Vertiv™ | Liebert® iCOM™ Installer/User Guide
84