Vertiv™ XTE 802G Generator Room Walk-In-Cabinet Description and Installation Manual
vii
General Safety Precautions
The following precautions shall be observed at all time when handling and installing the enclosure:
•
Observe all safety precautions against personal injury and equipment damage.
•
The procedures outlined in this manual are only recommended guidelines. Ensure that all NEC (National Electric Code) and
local codes for safety and wiring are followed.
-
Use listed two-hole compression connectors (lugs) to terminate all ground connections. Selected lug shall match wire
and type, and crimped applied as specified by the lug manufacturer.
-
Apply NO-OX-ID-A to all ground connections.
-
Insulation of field-wire conductors should be rated no less than 90
°
C, and sized in a manner that is consistent with the
NEC and local codes.
•
Always use an approved voltage detector, when approaching an enclosure, to verify no leaks or shorts are presents on the
external body.
•
Read “Specific Safety Precautions” starting on page viii in its entirety prior to attempting to handle or secure the enclosure.
•
A minimum of two persons are required to safely install the enclosure.
•
Hard hats and steel-toed boots should be worn while maneuvering the enclosure.
•
Safety glasses should always be on while on-site.
•
Safety gloves should be on when working in temperature extremes, with batteries, or with sharp objects.
•
All electricians, operators, and technicians have been trained for the task at hand.
•
Keep bystanders away.
•
Ensure that all personnel on site are familiar with the first-aid kit location and emergency procedures in the event of an injury.
•
Never leave the enclosure unattended. If leaving the site, close and secure the enclosure.
