Vertiv 588810200SK001, Руководство по установке, Страница: 11 / 18

Vertiv™ NetSure™ +24V Battery Tray Kit Installation Manual
Proprietary and Confidential © 2022 Vertiv Group Corp. 5
3.3 Installing and Connecting Batteries
Procedure
NOTE!
Refer to
Figure 3.2
as this procedure is performed.
1. If Battery Trays are Equipped With Circuit Breakers: Turn OFF the Battery Disconnect circuit breakers located on all
battery trays. Refer to
Figure 3.2 for locations.
2. Remove the battery retention bracket as shown in Figure 3.2 . To do so, remove the four 1/4-20 x 5/8” bolts and associated
washers.
3. Slide batteries into the tray, with the battery terminals toward the front as shown in Figure 3.2 . Slide batteries into the tray as
far as they will go.
NOTE!
The battery retention bracket can be oriented two ways to accommodate batteries of different lengths. A correctly
oriented bracket will fit snuggly against the batteries. If your batteries require the alternate bracket orientation shown in
Detail A of
Figure 3.2
, remove and reinstall the bullet-shaped spacers as shown in Detail A before performing the next step.
4. Reinstall the battery retention bracket. The spacers on the bracket should separate the batteries from each other. Secure
with the hardware removed in a previous step. Refer to
Figure 3.2 for washer location.
5. Connect two links supplied by the battery manufacturer between pairs of battery terminals as shown in Figure 3.2 . Use
hardware furnished by the battery manufacturer. Torque hardware to battery manufacturer’s recommendations.
6. Ensure the battery cable ends in all trays are insulated with sleeving before performing the next step.
DANGER! In multiple-tray installations, when batteries in one tray are connected, the battery cables in all trays will be
energized. Remove sleeving from and connect one cable at a time. Do not allow a cable end to contact the battery tray or
equipment rack.
WARNING! In the next step, observe correct polarity. Connect only cables labeled “+” to battery terminals labeled “+”.
Likewise, connect only cables labeled “–” to battery terminals labeled “–”.
7. Connect the cables found in the battery tray to the battery terminals, “+” to “+” and “–” to “–”. Observe correct polarity. Refer
to
Figure 3.2 . Secure with hardware furnished with the battery. Torque hardware to battery manufacturer’s
recommendations.
8. Repeat steps 1 through 7 for any remaining battery trays.
9. If Battery Trays Are Equipped With Circuit Breakers: To connect the batteries to the power system, turn ON the Battery
Disconnect circuit breakers located on all battery trays.