Vertical WAVE IP 2500, Руководство по установке

Страница: 99 / 236

Connecting to the Wave ISM 5
-
5
Chapter 5: Connecting to the Wave ISM from the administrator PC
Wave Server Installation Guide
2. On the General tab, click
Use the following IP address
, and enter the following
information:
IP address
: 192.168.205.x. “x” can be any number between 2 and 254, except for
10-13:
• 10 is reserved for the IP address of the Integrated Services Card (ISC1 or
ISC2, depending on the Wave Server model).
• 11, 12, and 13 are reserved for the IP address(es) of the Media Resource
Module (MRM). Depending on the model, an MRM requires 1, 2, or 3 IP
addresses. Note that on the Wave IP 500, only the MRMA model is supported,
which requires 1 IP address.
Subnet mask
: 255.255.255.0
3. Click
OK
to save your changes, and again to exit the Local Area Connection Properties
dialog.
4. If you are prompted to restart the your computer, do so.
Connecting to the Wave ISM
After configuring TCP/IP on the administrator PC, you are ready to connect to the Wave ISM
for initial configuration. (Initial configuration steps are is described in detail in the next
chapter).
You can connect to the Wave ISM from the administrator PC in any of the following ways:
• Network connection. See the next section.
• Local or remote modem connection. See page 5-10.
Although you can perform all Global Administrator Management Console tasks via a
modem connection, HotFix upgrades will be very slow, possibly taking several hours to
complete, and software upgrades will take even longer. HotFix or software upgrades will
run much faster if you connect to the Wave ISM via your network. Disconnects or very
low throughput due to unreliable phone line connections may make connecting via a
modem an unreliable option.
You can enhance Global Administrator Management Console performance, especially for
a slow modem connection, by installing client caching as described on page 7-27.
Release 4.0 June 20, 2013