Vertical WAVE IP 2500, Руководство по установке

Страница: 89 / 236

Connecting the Quad BRI module 4
-
27
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
To connect the E1 EuroISDN module:
1. Locate the RJ-48C port and DB-60 connector on the module.
2. Connect the E1 cable to the RJ-48C port.
3. Connect the serial cable from your external router to the DB-60 port.
The serial cable may be either a DB-60 male to DB-60 male cable, or a DB-60 male to
V.35 female DCE cable. In either case the DB-60 male connector goes to the DB-60
female port on the ISC1/ISC2.
Caution:
Use care when connecting or disconnecting the serial cable. Because of the
connector’s small size and high pin count, pins on the cable connector can be easily bent
and the DB-60 port may be damaged.
Connecting the Quad BRI module
The Quad BRI Module supports ISDN Basic Rate Interface (BRI) digital trunks, and provides
connectivity between the Wave Server and Central Office (CO) equipment supporting
Euro-ISDN BRI communication protocols. The Quad BRI Module supports 4 Euro-ISDN BRI
trunks and up to 8 simultaneous voice calls.
There are 4 RJ-45 connectors on the Quad BRI module.
The Quad BRI module is a partial-width module that can be installed in any module slot or in
any universal slot via a module converter.
To connect the Quad BRI module:
1. Locate the RJ-45 ports on the module.
2. Connect each port to a Euro-ISDN BRI trunk cable.
Release 4.0 June 20, 2013