Vertical SBX IP 320, Руководство по установке

Страница: 46 / 148

Main Board Unit 4
-
6
Chapter 4: Board Installation
SBX IP 320 Installation Guide
Switch, LED, and Connector
Before programming the System, switch 1-4 should be ON and then power cycle OFF and ON
to initialize the default System database. Once the database has been initialized, switch 1-4
should be placed in the OFF position to protect the database.
After putting the SW2 lithium battery switch ON to protect the RAM/RTC data, install the
option boards to the MBU.
Note:
• The SW2-DIP switch should be turned ON to protect the System database in case of
power failure.
• As needed, replace the batteries with the same or equivalent type recommended by the
manufacturer; the System will not function normally if the battery is incorrectly replaced.
• Dispose of used batteries according to manufacturer instructions and/or local government
regulations.
• The 4th pole of SW1 should be OFF to protect the features being programmed in Admin
programming after the System power up and initialization.
Table 4-7
MJ3 Pin Assignment (LAN)
CONNECTOR PIN NUMBER NO SIGNAL NAME FUNCTION
4, 5, 7, 8 RESERVED
1 TX+ Transmit Data
2 TX- Transmit Data
3 RX- Receive Data
6 RX+ Receive Data
Table 4-8
SW1 Functions
SWITCH FUNCTION OFF ON (DEFAULT)
1-1 Administration Programming Access Disable Enable
1-2 Command/Event Trace (Software Testing) Enable Disable
1-3 Simplified Message Desk Interface control
(SMDI - Voice Mail) SMDI ON SMDI OFF
1-4 Database Default on Power Up Disable Enable