CONGRATULATIONS!
Your new BriteStar Solar Aeration System by Vertex Water Features
includes a BriteStar Aeration cabinet with pre-assembled conduit
connections, two high efficiency solar panels, pre-assembled racking
and Vertex XL AirStations.
PRODUCT WARRANTY
3 year warranty on all components,
repair or replace any
defective part.
Not covered:
Air filters and compressor maintenance kit parts
5 year AirStation “No Questions” replacement policy
5 year solar panel warranty
All claims must be made to Vertex Water Features or an Authorized
Dealer. The customer is responsible for return shipping of any goods
for warranty inspection. After inspection, if the product shows a
manufacturing defect, Vertex will replace or repair parts at no cost to
the customer. Should inspection indicate non-warranty failure (faulty
installation, vandalism, negligence, etc.) warranty will be voided.
The period for all warranty work is equal to the remaining time period
of the original new equipment warranty. Warranty claims are based
on the date you purchase the product: mail the warranty card, call
844-432-4303 or go to www.vertexwaterfeatures.com/register-
warranty
WARNING! VOIDS WARRANTY:
Installing cabinet in a very low elevation may allow flooding to
occur - warranty does not cover damage from flood water that
destroys the compressor and/or electronics.
Installing the cabinet in an unusually dirty environment.
Excessive airborne dirt, sand or grit entering the cabinet will
damage the system.
Call your dealer or Vertex Water Features for help resolving
installation problems.
*Vertex reserves the right to change information without notice, and makes no
warranty, express or implied, with respect to this information. Vertex shall not
be liable for any loss or damage, including consequential or special damages,
resulting from the use of this info, even if loss or damage is caused by Vertex
negligence or other fault.
BriteStar
Owner’s Manual
Battery Free Solar Aeration Systems
BATTERY-FREE SOLAR AERATION
CHECK MATERIALS UPON DELIVERY
FOR PRODUCT DAMAGED IN DELIVERY:
The solar aeration system was properly
packed and accepted by the freight carrier for shipment. It is their responsibility to
deliver the system in perfect condition.
APPARENT DAMAGE OR LOSS:
If upon delivery the equipment or containers
indicate DAMAGE IN TRANSIT, such goods should be refused or not accepted until
the transportation company’s agent has noted such on the freight bill. A copy of
such bill will be given to you, noting the nature and extent of the damage. If any
part of shipment is LOST IN TRANSIT, have shortage noted on freight bill
by agent.
CONCEALED DAMAGE:
If damage is discovered, that was not apparent upon
delivery, notify the transportation company immediately to inspect damaged
equipment. The inspector will be required to provide a “CONCEALED BAD ORDER”
report. Inspections must be requested within 15 days of delivery. Do not move
damaged goods from original point of delivery. Retain all original packing and
containers for inspection. File a “FULL VALUE REPLACEMENT” claim against the
transportation company.
Hours of Operation:
M-F, 8am – 5pm EST © Vertex Water Features
(844) 432-4303
www.vertexwaterfeatures.com [email protected]
MATERIALS YOU NEED TO PROVIDE
(1) 3.5 in. OD, 3 in. ID steel pole. Standard length is 8 ft., though you may cut
shorter if you prefer the array to be lower. NOTE: The pole must be buried a
minimum of 3 ft. deep
Bags of Concrete: (12) 60lb bags or (9) 80lb bags
(2) 1/2” x 16” Rebar
(1) Bag of gravel for each AirStation
SAFETY NOTES
Please read the following instructions carefully before installing and operating your
system. Failure to follow the recommendations in this section may result in personal
injury or rescinding of the warranty agreement.
When near water always wear an approved life jacket and follow all water safety
guidelines.
Locate the cabinet on a solid support with adequate strength for the weight of
the unit.
Never push objects of any kind into the slots in the covers, as they may touch
dangerous voltage points or short out parts that could result in a risk of fire or
electrical shock.
Never override or “cheat” electrical or mechanical interlock devices.
Never attempt any maintenance or other activity that is not specified in
the user manual, or that is not specifically directed by an authorized Vertex
representative.
Never operate the system if unusual noises or odors are detected. Turn system
off by turning the breaker to the off position, and call Vertex to correct any
problems.
Before performing any maintenance and troubleshooting, disconnect the
electricity by turning the breaker to the off position.
TOOL CHECKLIST:
Gather everything before starting
(2) 7/16 Wrenches
(2) 9/16 Wrenches
(2) 3/4 Wrenches
A-Frame Ladder
Compass
Flat head screw driver
Level
Phillips Head Screwdriver
Post-hole digger
Shovel
Tape Measure