Vertex Standard VX-410 Series, Руководство по обслуживанию

Страница: 7 / 63

7
Cloning
The VX-410/-420 series includes a convenient Cloning feature, which allows the programming data from one trans-
ceiver to be transferred to another
VX-410/-420
series. Here is the procedure for Cloning one radio's data to another.
Optional Cloning Cable CT-27
1. Turn both transceivers off.
2. Remove the plastic cap and its two mounting screws
from the MIC/SP jack on the right side of the trans-
ceiver. Do this for both transceivers.
3. Connect the optional CT-27 cloning cable between the
MIC/SP
jacks of the two transceivers.
4. Press and hold in the PTT and Soft key assigned to
“ MONITOR ” while turning the transceiver on. Do this
for both transceivers (the order of the switch-on does
not matter). “
CLONE CLONE CLONE CLONE CLONE
” will appear on the displays (for
the VX-420 series) of both transceivers when Clone
mode is successfully activated in this step; in the case
of the
VX-410 series, no change will be observed at
this point.
5. On the Destination transceiver, press the Soft key as-
signed to “ MONITOR ”. “
LOADING LOADING LOADING LOADING LOADING
” will appear on the
LCD (for VX-420 series; for VX-410 series, the TX/
BUSY
indicator on the top of the radio will glow
Green).
6. Press the PTT switch on the source transceiver; “
SEND- SEND-
SEND- SEND- SEND-
ING ING ING ING ING
” will appear on the Source transceiver (for
VX-
420 series; for VX-410 series, the TX/BUSY indica-
tor on the top of the radio will glow Red), and the data
will be transferred.
7. If there is a problem during the cloning process, “
ER- ER- ER- ER- ER-
ROR ROR
ROR ROR ROR
” will appear on the LCD (for VX-420 series; for
VX-410
series, the
TX/BUSY
indicator on the top of
the radio will blink Red); check your cable connec-
tions and battery voltage, and try again.
8. If the data transfer is successful, the display will return
to “
CLONE CLONE CLONE CLONE CLONE
” (for
VX-420
series; for
VX-410
series,
the TX/BUSY indicator on the top of the radio will
turn off). Turn both transceivers off and disconnect the
CT-27 cable. You can then turn the transceivers back
on, and begin normal operation.
9. Replace the plastic cap and its two mounting screws.