Vermont Castings VSW30FTAL, Руководство по установке и эксплуатации для владельца жилья

Страница: 7 / 24

7 20300058
VSW30 Series Wood Stove
STOVE SETUP
7. With rear leg installed,
pivot the stove so the hold
down bracket is off the
pallet. The stove
should be resting
o n t h e
installed
leg on the
floor, one
s u p p o r t
bracket on the
pallet and the
partially loosened
support bracket
hanging free. Have
someone steady the
stove to avoid tipping.
8. Remove the remaining bolt
from the hold down bracket and
install front leg.
Figures 6
& 7
9 Pivot the stove or
twist the pallet
so the rear
corner of the
r e m a i n i n g
support bracket
is extended over
the pallet just far
enough to install the
rear leg.
10. Remove both of the bolts from the top rear section of
the hold down bracket and one of the bolts from the
top front section of the hold down bracket.
11. Pivot the hold down bracket out of the way just far
enough to install the other rear leg.
12. Pivot the stove or slide the pallet so that the three
installed legs are on the floor and the stove is
completely off the pallet.
13. Remove the final remaining bolt from the hold down
bracket and install the final leg.
ST1046
attach front leg
Figure 6
ST1046
ST1047
2 legs on
Figure 7
ST1047
STOVE SET-UP
1. Check that all brick and tubes are in place.
2. Select the proper location for the stove. These
appliances must not be installed any closer than the
minimum clearance to combustible materials shown on
Page 9 of this manual. The stove must be installed on
a non-combustible surface as shown on Page 9 of this
manual.
3. Remove packing material and packing labels from
glass.
FAILURE TO FOLLOW ThE MINIMUM CLEARANCE
REQUIREMENT ANd NON-COMBUSTIBLE SURFACE
REQUIREMENTS MAY RESULT IN AN UNSAFE INSTAL-
LATION
4. If noncombustible materials have been installed on the
walls, obtain the minimum clearances from either the
manufacturer of these materials or the local building
inspectors office.
5. Install the stovepipe INSIDE the flue collar on the top
of the stove between the stove and chimney.
6. dO NOT use a grate to elevate the fire.
STOVE PIPE
1. Make sure your chimney and chimney connector meets
safety codes. Check with authorities having jurisdiction
in your area.
2. All pipe sections must be connected with the male end
(crimped end) toward the stove.
3. Fasten the stove pipe to the flue collar by the use of three
sheet metal screws. Do the same at each additional joint
to make the entire installation rigid.
4. Maintain the required diameter flue for the entire
installation.
5. If you are connecting the stove to an old masonry flue,
be sure to have it inspected for cracks and general
condition. Resizing with a stainless steel liner may be
required.
6. It is recommended that no more than two 90 degree
bends be used in the stovepipe installation. More than
two 90 degree bends may decrease the amount of draw
and possible cause smoke spillage.
7. A damper is not required in this installation. Remove
any damper plate in the chimney or secure in the OPEN
position.
8. Single wall flue pipe assemblies must not exceed 10
feet (3 meters) in overall length.