Vermont Castings VSW30FTAL, Руководство по установке и эксплуатации для владельца жилья

Страница: 17 / 24

17 20300058
VSW30 Series Wood Stove
FAQS
known as negative pressure. Under extreme conditions
of negative pressure the combustion by-products can be
drawn from the chimney into the house. This condition is
commonly referred to as down drafting.
There are several factors that impact the amount of air
available in the home. Increased amounts of insulation,
vinyl windows, extra caulking in various places and door
seals can all keep heat in but may also make a home too
airtight. If you are in doubt about whether or not there is
sufficient air in your home for your stove, curtail from using
those appliances known to consume the air where possible,
or open a window or door to allow air to enter the home.
b.
Environmental Conditions
High trees, low lying house location such as in a valley, tall
buildings or structures surrounding your house and windy
conditions can cause poor draft or down drafting.
c.
Cold Chimney Temperature
Avoid cold chimney temperatures by burning a hot fire for
the first fifteen to forty minutes, being careful not to over
fire. If any part of the chimney or parts of the stove start to
glow, you are over firing the stove. Where possible, install
a temperature gauge on the chimney so temperature drops
can be seen.
d.
Chimney Installation and Maintenance
Avoid using too many elbows or long horizontal runs.
If in doubt, contact a chimney expert and/or chimney
manufacturer for help. Clean chimney, rain caps and
especially spark arrester regularly, to prevent creosote
build-up, which will significantly reduce chimney draw and
possibly a chimney fire.
11. Should I close or open the air control fully when
shutting down the stove?
Just before shutting down the stove, run on high for a few
minutes. This allows the chimney temperatures to remain
as high as possible for as long as possible. Cold chimney
temperatures create creosote.
NOTE: This sheet is intended as an aid and does not
supersede any local, provincial or state requirements.
Check with officials or authorities having jurisdiction in
your area.