Vermont Castings VSW30FTAL, Руководство по установке и эксплуатации для владельца жилья

Страница: 14 / 24

14
20300058
VSW30 Series Wood Stove
MAINTENANCE
4. Work baffle and insulation from top of stove. Figure
17
NOTE: When reinstalling baffle make sure the baffle stops
at the edge of center baffle plate. Figure 18
ST1057
remove baffle
Figure 17 -
Remove Baffle
ST1057
C
ST1058
replace baffle
Figure 18 -
Reinstall Baffle
ST1058
REMOVE FIREBRICk
To remove firebrick, lift up from bottom and rotate outward.
Figure 19
ST1052
remove firebrick
Firebrick
ST1052
Figure 19 -
Remove Firebrick
GLASS CARE
Replace glass only with high temperature ceramic
available from your local Vermont Castings dealer
The following use and safety tips should be observed:
1. Inspect the glass regularly for cracks and breaks. If you
detect a crack or break, extinguish the fire immediately,
and contact your dealer for replacement.
2. Do not slam door or otherwise impact the glass. When
closing doors, make sure that logs or other objects do
not protrude to impact the glass.
3. Do not clean the glass with materials which may scratch
(or otherwise damage) the glass. Scratches on the glass
can develop into cracks or breaks.
4. Never attempt to clean the glass while unit is hot. Light
deposits are normal. Heavier deposits may be removed
with the use of a readily available oven cleaner.
5. Never put substances which can ignite explosively in
the unit since even small explosions in confined areas
can blow out the glass.
6. This unit has an air wash system designed to reduce
deposits on glass.
GASkET REPLACEMENT
After extensive use, the sealing material which provides
glass and door seal may need to be replaced if it fails
to sustain its resilience. Inspect glass and door seal
periodically to ensure proper seal: if gaskets become
frayed or worn, replace immediately. Contact your Vermont
Castings dealer for approved replacement parts. Refer to
replacement parts list in this manual.
The following steps should be followed for glass gasket
replacement:
1. Ensure appliance is not in operation and is thoroughly
cooled
2. Remove door and place on a protected flat surface.
3. Remove screws and glass clips.
4. Lift glass out.
5. Remove old gasket and clean glass.
6. Sand gasket groove and wipe clean (rubbing alcohol
works well).
7. Put a thin film of gasket cement on the door.
8. Replace new gasket starting at the top center of the
door.
9. Trim to length and butt ends together. Remove all
excess cement.
10.Replace glass in door, being sure not to over-tighten
screws and clips.