24
DVA4136 Series Direct Vent Gas Fireplace
10010270
�����
��������������������������
�����
Top Right Log
(M6)
Top Center Log
(M4)
Figure 41
LG513
It is important to periodically perform a visual check of
the pilot and burner flames. Compare them to Figures
43 and 44.
If the flame patterns appear abnormal contact a
qualified service provider for service and adjustment.
Flame Characteristics
������
����������������
����
SIT EN/EP
FP1541
Fig. 43
Correct pilot flame appearance.
�����
�����������������
�����
Rear Log
(M1)
Top Front Log
(M6)
Top Center Log
(M4)
Top Right
Log (M5)
Front Log
(M2)
Ember Material
Lava Rock
LG514
Figure 42
5. Place the top center log (M4).
Place the two (2) holes in the
bottom of the log over the pins on
the front log. The top of the log will
rest against the rear log. (Fig. 41)
6. Place the top right log (M5). Place
the bottom rectangular sot of this
log onto the right side of the rear
log. The cross section of the log
will rest on top of the front log.
(Fig. 41)
7. Place the top front log (M6). Place
the bottom rectangular slot of this
log onto the knob of the left log.
Place the front of the log on the
grate bar. (Fig. 42)
8. Place ember material on top of
front burner. Separate the ember
material into small pieces approxi-
mately 1/2” (13 mm) diameter and
keep 1/2” (13 mm) space between
the ember pieces.
9. Place large lava rock onto the two
sides and front of the burner tray.
(Fig. 42)
CAUTION:
Do not place
any lava rock material on
the burner housing assem-
bly.
