17
10001028
RFSDV22/32/42 Freestanding Direct Vent Fireplace
RFSDV42
1 . Remove both Bay Window brass trims (See Trim
Removal section).
2. Open the two clamps (Fig. 31) underneath the Bay
Window that holds the Bay Window Frame and
Glass Frame.
3. Lift and unhook the Bay Window assembly at the
top.
4. Lift and unhook the Glass Frame at the top.
Window
Frame
Pull
Clamp Hook
Push
Clamp
Hook
FP1346
Fig. 31 RFSDV42 glass removal.
Glass Cleaning
It will be necessary to clean the glass periodically.
During start-up condensation, which is normal, forms
on the inside of the glass and causes lint, dust and
other airborne particles cling to the glass surface. Also
initial paint curing may deposit a slight film on the
glass. It is therefore recommended that the glass be
cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend
gas fireplace glass cleaner). After that the glass should
be cleaned two or three times during each heating
season depending on the circumstances present.
Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Installation of Logs &
Burner Lava Rock Material
RFSDV22, RFSDV32 (Fig. 32)
1 . Remove front glass. (See "Glass Removal" section)
2. Remove logs from packaging.
3. Place rear log (KR4) on rear bracket (ensure log is
seated properly, leveled and centered to the unit), so
it will not move from side to side and it is firmly
positioned on the bracket.
4. Slip front ember log (KR1) down in the front deflec-
tor.
5. Place front left log (KR2) on top burner, left side.
Use log's bottom holes to locate it into the left
bracket log locator studs.
6. Place front right log (KR3) on top of burner, right
side. Use log's bottom holes to locate it into the right
bracket log locator studs.
7. Place small lava rocks and ember material on top of
burner. (See Fig. 32 for proper location).
8. Place top left log (KR5) onto locator notches. En-
sure log is secure.
9. Place top right log (KR6) onto locator notches.
Ensure log is secure.
Top logs must be placed properly into
notches
KR2
KR5
KR6
KR4
KR3
KR1
Burner Lava Rock
Placement
LG280
Fig. 32 RFSDV22/32 logs and burner lava rock placement.
RFSDV42 (Fig. 33)
1 . Remove bay window assembly and glass frame (see
"Glass Frame Removal" section).
2. Remove logs from packaging.
3. Place rear log (SR4) on rear bracket. Ensure log is
seated properly, leveled and centered to the unit, so
it will not move from side to side and it is firmly
positioned onthe bracket.
4. Slip front emberlog (SR1) down in the front deflector.
5. Place front left log (SR2) on top of burner, left side.
Use log's bottom holes to locate it into the left
bracket log locator studs.
6. Place front right log (SR3) on top of burner, right
side. Use log's bottom holes to locate it into the right
bracket log locator studs.
7. Place burner lava rock on top of burner. (Fig. 33)
8. Place top right log (SR6) onto locator notches.
Ensure log is secure.
9. Place top left log (SR5) onto locator notches. En-
sure log is secure.
