8.
Push the washer against the stove wall and use needle nose pliers to insert the retaining clip
onto the groove in the rod to lock the rod in place
(Fig. 9 previous page)
.
NOTE: This is a good time to check the condition of the damper gasket and replace it, if
necessary.
9. Re-position the damper adjuster plate right side up and secure it to the damper using
the 7/16” bolt and nut.
10.
Check the damper rod/damper plate action to be sure that the damper seals tightly in the
closed position. Rotate the adjustment bolt
(a in Fig. 10)
, clockwise to improve the seal
against the gasket.
11.
Inspect the catalytic element and carefully clean any debris from it using a vacuum. Be sure
the interam gasket
(b in Fig 10)
is properly positioned around the element. Replace the
refractory package.
12.
Replace the top plate and secure it with the bolts and washers used previously. Gradually
tighten the bolts evenly, alternating from side to side.
Figure 10
WoodmansPartsPlus.com
