Vermont Castings • Apsen C3 Installation Manual_R2 • 2019 - ___ • 07/19
4
8390-950i
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Hearth & Home Technologies WILL NOT warranty
appliances that exhibit evidence of firing. Evidence of firing
includes, but is not limited to:
• Warped Damper
• Deteriorated refractory
• Deteriorated interior components
E. Non-Combustible Materials
Material which will not ignite and burn, composed of any
combination of the following:
- Steel
- Plaster
- Brick
- Iron
- Concrete
- Tile
- Glass
- Slate
Materials reported as passing
ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace of 750° C.
F. Combustible Materials
Material made of/or surfaced with any of the following
materials:
- Wood
- Compressed Paper
- Plant Fibers
- Plastic
- Plywood/OSB
- Sheet Rock (drywall)
Any material that can ignite and burn: flame proofed or not,
plastered or non-plastered.
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with the
UL1482-11, UL 737-11, (UM) 84-HUD and NPFA211 in
the U.S.A. and the ULC S627-00 and CAN/CSA-B365
Installation Codes in Canada.
APPROVED FOR MOBILE
HOME INSTALLATIONS IN the USA & CANADA.
NOTE: Hearth & Home Technologies, manufacturer of this
appliance, reserves the right to alter its products, their
specifications and/or price without notice.
!
WARNING
This product and the fuels used to operate this product
(wood), and the products of combustion of such fuels, can
expose you to chemicals including carbon black, which
is known to the State of California to cause cancer, and
carbon monoxide, which is know to the State of California
to cause birth defects or other reproductive harm. For
more information go to: www.P65Warnings.ca.gov
G. California Safety Information
H. Smoke, CO Detectors & Safety Tips
Smoke and CO Detectors
The use of smoke and carbon monoxide (CO) detectors
throughout the home is strongly advised, even if not
required by building codes or insurance regulations.
It is a good idea to install a smoke detector in the living
areas and each bedroom. Follow the smoke/CO detector
manufactures placement and installation instructions and
maintain regularly.
You may not, however, wish to install a detector in the
immediate vicinity of the stove. Depending on the sensitivity
of the unit, the alarm can be set off while you are tending
the fire or emptying the ashes. If you install a detector in the
same room, locate it as far away from the stove as possible.
Safety Tips
Conveniently locate a “Class A” fire extinguisher to contend
with small fires. Be sure the fire extinguisher works and
is clearly visible. All occupants of the house should know
where it is, and how it operates. Have heavy stove gloves
available near the stove. Have special safety accessories
(e.g., Child Guard Screen) available for use if small children
will be in the home.
In the event of a stove pipe or chimney fire….
• Evacuate the house immediately
• Notify the fire department
• If the fire isn’t too threatening, closing down the stove
tight, (damper, primary air, all doors) will help to smother
the fire.
• Inspect your stove, vent pipe and chimney for any
damage caused by the fire and correct any damage
before using your stove again.
Fire Risk
• Do not leave the fire unattended when the
door is unlatched
• Operate only with front doors and ash pan
door closed.
• Unstable firewood could fall out of the firebox
creating a fire hazard to your home.
WARNING
!
