Vermont Castings • Apsen C3 Installation Manual_R2 • 2019 - ___ • 07/19
3
8390-950i
A. Appliance Certification
B. BTU & Efficiency Specifications
1
Important Safety Information
MODEL:
Aspen C3
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
0135WS044S / 0135WS044E
TYPE:
Solid Fuel Type Room Heaters /
Space Heaters for Use with Solid
Fuel
STANDARD(s):
ASTM E2515, ASTM E2780, UL
1482-2011 (2015), ULC-S627-00,
CSA B415.1
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
WARNING
!
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied
with it).
• Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
C. Mobile Home Approved (USA & Canada)
•
This appliance is approved for mobile home installations
in the USA & Canada when not installed in a sleeping
room and when an outside combustion air inlet is
provided.
•
The structural integrity of the mobile home floor, ceiling,
and walls must be maintained.
• The unit must be bolted to the floor. This can be done
using an appropriate fastener for the application.
•
The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and
chimney must be listed to UL103 HT or a listed UL-1777
full length six” (152mm) diameter liner must be used.
•
Outside air must be installed in a mobile home installation.
D. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact
your dealer for replacement glass.
EPA Certification Number:
EPA Certified Emissions:
1.99 g/h
*LHV Tested Efficiency:
81.4%
**HHV tested Efficiency:
75.2%
***EPA BTU Output:
17,500
****Peak BTU/Hour Output:
35,200
Other Important Information
Vent Size:
6 Inch (152 mm)
Firebox Size:
1.25 cu. ft.
Max. Wood Length:
18"
Ideal Wood Length:
16"
Fuel
Seasoned Cordwood
(20% moisture)
* Weighted average LHV efficiency using Douglas Fir
dimensional lumber and data collected during EPA
emissions test.
**
Weighted average HHV efficiency using Douglas
Fir dimensional lumber and data collected during EPA
emissions test.
***
Efficiencies are based on test results calculated using
B415; these calculated efficiencies are then used to
calculate output BTU’s.
****
A peak BTU out of the appliance calculated using the
maximum first hour burn rate from the High EPA Test and
the BTU content of cord wood (8600) times the efficiency.
Certified to comply with 2020 US particulate emissions
standard using crib wood
at 1.99 g/hr., Certified to comply
with 2020 particulate emission standards for single burn rate
heaters. This single burn rate wood heater is not approved
for use with a flue damper.
This wood appliance needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood appliance in a manner inconsistent with operating
instructions in this manual.
