Vermeiren Forest 3+, Руководство пользователя, Страница: 12 / 24

Forest 3+
2020-01
Using your wheelchair
10
EN
NL
3.6.1 Armrest width
Adjust the width of the armrests as follows (range 25
mm: step less / on each side):
1. Loosen the lever  on the back of the wheelchair
just below the seat frame.
2. Adjust the armrest to a comfortable width.
3. Tighten the lever
 properly.
4. Check that the armrests are positioned
identically on both sides.
The maximum adjustment will be indicated by the
triangle
 . The triangle must be completely visible.
It is also possible to completely remove the armrest by
following the above instructions.
3.6.2 Arm pads
The arm pads can be adjusted in height (stepless)
and angle (7,5° step):
1. Turn the star knob (1) a few turns anticlockwise.
To adjust the angle, turn it four turns minimally.
2. Pull/push the arm pad lightly to adjust the height.
3. Hold the arm pad at the desired angle.
4. Turn the star knob clockwise until it is finger-tight.
5. Repeat this for the second arm pad.
6. Make sure that both arm pads are firmly secured.
3.6.3 Mounting or removing the footrests
The wheelchair has two footrests that can be folded away to the side with a 3 point attachment
system (1, 2, 3 on the figure below). This system provides a steady, play-free connection of the
footrest to the seat frame.
Mounting the footrests is done as follows:
1. Hold the footrest sideways at the outside
of the wheelchairs frame and mount the
pins (1) into the holes (2).
2. Turn the footrest inwards till the pin click
in the hole of the attachment point (3).
3. Turn the foot plates downwards.
To take off the footrests:
1. Fold the foot plates upwards.
2. Pull or push on lever (4).
3. Turn the footrest to the outside of the wheelchair until the hole come loose of the pin from
attachment point (3).
4. Pull the footrest upwards until the pins (1) comes out of the holes (2).
3
2
3
4
1
MINIMUM
MAXIMUM