Vermeer S450TX, Быстрый старт

Страница: 71 / 100

S450TX Mini Skid Steer Preparation 40-11
Attachment - Install
Step 1: Position attachment on a level surface with
sufficient area behind it to accommodate
the machine.
Step 2: Ensure pins are rotated so that tops of pins
face outward as shown
(1) .
Step 3: Start machine, and lower lift arm. Tilt
loader mounting plate forward slightly.
Step 4: Drive machine FORWARD, aligning loader
mounting plate
with attachment.
Step 5: Once top edge of mounting plate enters under lip of attachment mount as shown (2) , raise lift arm
while tilting mounting plate back to securely engage attachment.
Step 6: Raise attachment sufficiently to clear the ground. Tilt attachment plate back fully.
Step 7: Ensure Ground Drive and Lift/Tilt Controls are in NEUTRAL, and shut off machine and remove key.
Step 8: Rotate pins 180° so that pins engage and extend through bottom of attachment
mount and are visible beneath attachment mount. Tops of pins must face inward
as shown
(3) .
NOTICE: Ensure pin ends extend through and are visible beneath attachment mount.
Step 9: If attachment requires hydraulic power, see “Hydraulics - Attach.” Refer to
“Hydraulics - Attach,”
page 40-14.
1
2
3