504PRO_604PRO_o-m2_00
-
504/604 PRO Baler
Safety Messages 2-3
2.2
Safety Instructions
WARNING:
Even when all instructions have been read and understood there are potential hazards with the machine.
Always handle the machine with care to avoid injury to yourself and others!
WARNING:
Do not do work on the magnets of the blade holders if you have a cardiac pacemaker or other implant that
can be impaired by magnetic fields.
•
Before starting work perform a visual inspection of the machine. Check whether any device has been changed or is missing and pay attention to
any unusual noise or leaks which occur during operation.
•
All protective devices, as for example guarding shields are for your safety! Never operate the machine with defective or removed guarding
shields.
•
Keep all safety relevant parts always in correct function. Before operating all guards and shields must be mounted and closed!
•
Never perform maintenance or repair works during machine operation.
•
In case of all work on movable parts or in the range of action of movable parts: Follow Shutdown Procedure on page 6-1 and disconnect
driveline from power take-off. Interrupt electrical connection between tractor and machine.
•
Pressurized fluid can penetrate body tissue and result in serious injury or death(see page 2-14). Leaks can be invisible. Keep away from any
suspected leak. Relieve pressure in the hydraulic system before searching for leaks, disconnecting hoses, or performing any other work on the
system. If you must pressurize the system to find a suspected leak, use an object such as a piece of wood or cardboard rather than your hands.
When loosening a fitting where some residual pressure may exist, slowly loosen the fitting until oil begins to leak. Wait for leaking to stop
before disconnecting the fitting. Fluid injected under the skin must be removed immediately by a surgeon familiar with this type of injury.
•
Bring no metal parts close to the machine, as long the electric control is in operation (e.g. tools, safety boots with metal caps). Reason:
unintentional triggering of proximity switches and thus unexpected machine movement.
•
When carrying out work on the opened tailgate: apply tailgate safeguard (see page 2-15).
•
During work in the vicinity of the net knife: fit net knife safeguard (see page 2-16).
•
Never remove any crop material from the machine while the drive is running, or while the disconnected machine is still moving. Always switch
off driveline and tractor engine first.
•
Ensure tractor operator is the only person riding the tractor, unless the tractor is equipped with an approved trainer seat and seat belt. Riding
on the baler is prohibited!
•
Never step onto the maintenance platform while machine is in motion. Before stepping onto the maintenance platform: stop machine, switch
off driveline and tractor engine, take out ignition key and wait for all movement to stop
https://tractormanualz.com
Содержание 504 PRO
Страница 112: ...504PRO_604PRO_o m2_00 504 604 PRO Baler Operating the Machine Baler 9 9 Figure 66 Locking hook https tractormanualz com ...
Страница 149: ...504PRO_604PRO_o m2_00 504 604 PRO Baler Technical Data 13 3 Figure 85 Baler dimensions https tractormanualz com ...
Страница 150: ...INTENTIONALLY BLANK 504PRO_604PRO_o m2_00 Technical Data 504 604 PRO Baler https tractormanualz com ...
Страница 153: ...https tractormanualz com ...
