-
-
-
-
13
VERLINDE reserves the right to alter or amend the above information without notice.
02/2010
The trolley can be adjusted according to the different track widths.
Procedure:
-
Check width B of the track
-
The distance B’ between the wheel flanges can be adjusted using the spacers (1) and
washers (2). Make sure that the suspension pin (3) is centered on the track. Depending
on the tolerances of the washers and spacers, the stacking can be different on the left
side and on the right side.
-
In any case, provide at least one washer outside the flange (4), under the nut (5)!
-
After adjustment, tighten the nuts (5) and reinsert the pins (6).
Caution:
When adjusting dimension B’ between the rollers, add the track width:
For trolleys up to 2000kg: up to 3mm C
For trolleys in excess of 3000kg: from 3 to 5mm C
The above values are for guidance only. The clearance depends on the tolerance and the
quality of the track.
1.8
1.8
1.8
1.8
Assembly on the track
Assembly on the track
Assembly on the track
Assembly on the track
At this stage the distance between the wheel flanges is set.
The trolley can be introduced through either end of the hoist track.
If this is not possible – e.g. if the mechanical stops or limit switches are already in place – the
trolley can also be installed through the lower flanges. In this case remove the nuts on one
side of the trolley and move the flanges apart. Reassemble all the components and make
sure that dimension C is correct.
