VERITAS Access 3340, Справочник по командам

Страница: 37 / 110

Network > Gateway
Network > Gateway
– Add or delete routing information.
SYNOPSIS
Gateway Add GatewayIPAddress [TargetNetworkIPAddress] [Netmask]
[InterfaceName]
Gateway Delete TargetNetworkIPAddress [Netmask]
Gateway Show IPVersion
DESCRIPTION
Use this command to add or delete a route from the kernel routing table. With this
command you can also view the kernel routing table. Refer to Linux route man page
for more advanced use cases.
With this command you can define the IPv4 address that you plan to add or delete
as well as display the current gateway information. If multiple networks are added
to the appliance configuration, you can use the
Gateway Add
command to add the
gateway to all of the destination networks.
OPTIONS
Gateway Add GatewayIPAddress [TargetNetworkIPAddress] [Netmask]
[InterfaceName]
Add a route to a kernel routing table.
Where the GatewayIPAddress variable is the new IPv4 gateway address. The
TargetNetworkIPAddress is the target network IPv4 address. The Netmask
variable is the target network netmask, and
InterfaceName
is the interface
name. The
TargetNetworkIPAddress
,
Netmask
, and
InterfaceName
are
optional when you set up the default gateway. After the default gateway has
been added, you must use these fields to add any additional gateways.
Gateway Delete TargetNetworkIPAddress [Netmask]
Delete the route from the kernel routing table.
Where TargetNetworkIPAddress is the target network address. The Netmask
variable is the target network netmask.
Gateway Show [IPVersion]
Display the gateway and the route information. Here, [IPVersion] parameter is
an optional parameter. It defines the IP protocols - IPv4 and IPv6. If you do
37 Main > Network
Network > Gateway