Cluster > Configure
Cluster > Configure
– Configure the Access cluster on the appliance.
SYNOPSIS
Configure
DESCRIPTION
Use this command to configure the Access cluster on the appliance from the current
node.
Note the following before you run the command:
■
The Access cluster configuration is only allowed to run from one node. Make
sure that the Access cluster configuration process is not already ongoing on the
current node or other nodes.
■
Make sure that you have the node management IP addresses of the appliance
nodes for clustering.
■
Make sure that you have reserved enough IP addresses for use as the physical
and the virtual IP addresses of the Access cluster. At least four continuous IP
addresses must be reserved for each type.
Do not run the
Configure
on the current node in the following scenarios:
■
When the cluster configuration process is already running on another node of
the Access appliance.
■
When the node has been factory reset without resetting the storage, and the
Access cluster remains on the other node.
■
When the node is an unconfigured node that is used to replace a faulty node in
an Access cluster.
OPTIONS
Configure
Use the command to configure the Access cluster on the appliance.
14
Main > Manage > Cluster
Cluster > Configure
Содержание Access 3340
