Verint Nextiva S1900e Series, Руководство пользователя

Страница: 18 / 79

2: Configuring and Installing the Device
8 Verint Video Solutions
11. Select the unknown device, then click Configure . In the Reconfigure unit? confirmation
window, click Yes .
The New Network Configuration window appears.
12. To use DHCP (Dynamic Host Configuration Protocol), check Use DHCP . Otherwise,
enter the IP address, subnet mask, and gateway of the device, as provided by your
network administrator.
For more information about DHCP, see page 43.
13. Click OK .
The device reboots with its new network configuration. It may take up to 20 seconds.
14. In the Units tab, click Discover .
The new S1900e device appears.
15. Select the device, then click Configure .
16. Configure the serial port parameters to match those of the target equipment (for
instance, camera or PTZ keyboard).
For more information, refer to the SConfigurator User Guide .
The S1900e initial configuration is now complete. You perform further configuration with
the web interface (see page 17), SConfigurator, or a video management software from
Verint Video Solutions.
Using the Encoders
The composite signal of a video input for the transmitters is sent to two separate encoders.
You can have the following scenarios with regards to the encoder use:
Note: You should not use the web interface and a video management software at the same
time.
Scenario Encoder 1 Encoder 2
point-to-point point-to-point unused
video management software view at rate A record at rate B
web interface web viewing point-to-point