Verint Nextiva S1100, Руководство пользователя

Страница: 46 / 107

4: Using the Configuration Assistant
34 Verint Video Intelligence Solutions
To perform a basic configuration:
1. At the bottom of the Unit Information pane, click Quick Setup.
The Quick Setup pane appears.
2. Select the country of operation of the pair of devices.
You must assign the proper country to comply to the DFS/TPC regulations, if applicable,
and to use the proper set of frequency channels.
3. If your devices are part of a repeater system, enable the repeater mode.
4. Change the wireless passkey of the devices:
†
If the devices form a point-to-point system, enter the passkey common to the
transmitter and receiver.
†
If the devices are in repeater mode, enter two different passkeys.
5. Assign a meaningful name to the devices.
6. Perform other changes, if required.
7. Click Save.
If there is a functional RF communication between the devices, the Configuration
Assistant sends the relevant parameters to the transmitter. Otherwise, a message
appears, asking you to connect the transmitter to the COM port of the computer.
The devices reboot.
Performing an Advanced
Configuration
In addition to the quick setup pane, you have access to a more elaborate set of parameters.
You can use them to fine tune the configuration of your devices, for instance if you are
colocating many systems or troubleshooting your devices with a customer service
specialist. You have access to the following configuration parameters:
„
General
„
Audio
„
Video
„
Wireless
„
Serial port