VeriFone MX800 Series, Руководство по установке, Страница: 21 / 40

I
NSTALLATION
Power Up with the Multiport Cable
M X 800 S
ERIES
I
NSTALLATION
G
UIDE
21
V
E R
I
F
O
N E
C
O
N F
I D
E N
T I
A
L
T E
M
P L
A T
E
R
E V
E
Connecting to the
Ethernet LAN
To connect the M
x
800 Series terminal to an Ethernet LAN through the 10BaseT
port, using a standard Ethernet cable, insert the LAN cable from the LAN router or
hub into the 10Base-T port on the bottom of the M
x
800 Series terminal.
Connecting to USB
Host or Hub
Connecting to a USB host or hub requires a VeriFone USB cable (VPN 22982-xx).
To connect to a USB host or hub:
1
Insert the modular plug on the USB cable into the USB jack.
2
Route the cable through the slots to the desired exit side.
3
Plug the other end of the USB cable into the USB host or hub.
Power Up with
the Multiport
Cable
This section describes how to connect the M
x
800 Series terminal to a power
source with the multiport cable.
If connected to an ECR, the M
x
800 Series terminal gets power from the ECR.
1
Make all other connections before connecting the power pack.
2
Insert the multiport cable connector into the port on the back of the M
x
800
Series terminal (see Figure 13 ).
3
Route the cable through the slots to the desired exit side.
4
Plug the power pack into an indoor electrical power outlet ( Figure 13 ).
Figure 13 Power Pack Connection
If no application is installed in the terminal, the message
DOWNLOAD NEEDED
displays for a moment, then the main M
x
800 Series terminal screen displays. An
application-specific prompt displays when an application executes.
NOTE
The M
x
800 Series series terminal can be connected to an ECR through the USB
cable. When connected through a USB cable, the M
x
800 Series series terminal
gets power through the USB cable and does not require the multiport cable.
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.