VERDER 3508, Инструкции по установке, эксплуатации и обслуживанию

Страница: 7 / 36

Products with a factory fitted supply cable are designed to be wired directly to an
isolator or fitted with a line plug.
Products without a factory fitted supply cable require a permanent connection to a
fused and isolated supply. The product's electrical access panel should be temporarily
removed, and connections made to the internal terminals.
When connecting the product to the power supply, the plug or isolating switch should
be accessible, easy to remove, and within reach of the operator.
The supply MUST incorporate an earth (ground).
Supply Terminal Label Cable Colour
Supply Types
Live - Neutral
Reversible or Live-
Live
1-phase L1 Brown to live
to either power
conductor
(For USA 200-240V,
connect L1)
N / L2 Blue to neutral
to the other power
conductor
(For USA 200-240V,
connect L2)
PE Green/ Yellow
to earth
(ground)
to earth (ground)
Electrical Connection Details:
2.4 Gas Supply Connections
High quality bulkhead connectors are provided for the connection of suitable gas. The
incoming supply piping should measure 6 mm outside diameter
When fitting the incoming pipe refer to the following instructions, this will ensure a
leak-free joint is made. The Swagelok fittings will allow disconnection and re-
connection many times providing the instructions are followed.
The gas should be clean, dry and free from impurities.
Gas Supply Connection Pipe
CO
2
ø6 mm
7