DNA desking
DB 22/2; 20/2; 18/2; 16/2; 14/2; 12/2
DNB 22/2; 20/2; 18/2; 16/2; 14/2; 12/2
DNA single bench unit
2 x DBT----
2 x (pair)DSH
2 x (pair)DSH
2 x (pair)DR 22/20
/18/16/14/12/08
1 x (pair)
DR 12/16
6 mm Allen key
4 mm Allen key
Equipment Required
(not included)
Fixings
To start, arrange your rails into lateral
rails and cross rails. There will be two
pairs of rails of the same length, these
are the lateral rails that will span the
width of the bench. If your bench is
1.2m wide they will be DR12, 1.8m will
be DR18 etc. The remaining pair will
usually be DR12 or DR16 and these span
the depth of the bench.
Take one of the corner legs and one of
the lateral rails. With the holes in the rail
facing upwards, insert either end onto
one of the metal lugs at the top of the
leg. If the beam will not slide on easily
ensure that the bolts in the lug are fully
retracted by turning them clockwise
with the 6mm Allen key.
With the rail in place, put the a 6mm
Allen key through one of the holes in its
top and into the allen bolt in the lug of
the leg. Turn this
anti-clockwise
as if to
undo the bolt. This will raise the bolt up
and force it against the inside of the
rail, locking it in place. Repeat this with
the bolt directly next to the one you
have just turned. The rail should now be
locked onto the leg.
2 x (pair) DCL
12 x 6mm x 26mm
mush head screws