INSTALLATION MANUAL
DROP-ARM AWNING V120 - NAPOLI
13227648-190828EN
5
Subject to misprints, errors and technical modifications.
2.1 Marking the holes for the drop-arms
Mark the drop-arms following the drawing below. The drop-arms need to be placed in one line. If the positions
of the drop-arms are not levelled, the awning will not function well. The pictured sizes are the minimal sizes that
the drop-arm needs to fall inside the drop-arm awning.
2.2 Drilling the holes
Drill the installation holes. We advise to use a masonry drill if the wall is made of stone or concrete. Use matching,
high quality plugs and bolts (standard A2 or for a sea climate A4). Install the drop-arm to the wall by first fixing it on
the bottom side (fig 2.2).
Remove the tape from the arm (fig 2.3). Attention! The arm is under tension and will unfold immediately!
Fixate the top side (fig. 2.4).
2. Installation of the drop-arms
fig. 2.1 Measuring the drop-arms
fig. 2.2 Fixate the bottom of the drop-arm
fig. 2.3 Remove the tape
fig. 2.4 Fixate the top of the drop-arm
Control side
Manual outside: 48 mm
Manual inside: 13 mm
Electrical: 13 mm
Proj 120 mm =
Bottom arm guide
13 mm