Vents VENTS RTS-1-400, Руководство пользователя

Страница: 5 / 12

INSTALLATION AND CONNECTION
CUT OFF POWER SUPPLY BEFORE ANY OPERATIONS ARE PERFORMED.
DO NOT LAY THE CABLE IN CLOSE PROXIMITY TO THE CONTROL PANEL CABLE!
WHILE ROUTING THE CONTROL PANEL CABLE DO NOT COIL THE EXTRA LENGTH.
1. Fix the junction box to the wall.
2. Remove the packaging material from the temperature controller. Carefully detach the front control panel from the casing.
Using excessive force can cause a breakdown of the temperature controller.
3. Connect the wires to the terminals of the temperature controller according to the wiring diagram.
4. Insert the casing into the junction box 86x86 mm.
5. With the help of two mounting screws, fix the casing of the temperature controller to the junction box.
6. With the help of a level, adjust the position of the temperature controller casing, then tighten the fastening screws (levelling effects
only the appearance and has no influence on operation of the temperature controller).
7. Install the front panel on the casing of the temperature controller by pressing it until it clicks.
Display (Fig. 2):
indicates that the temperature controller is in night mode
9
indicates that the temperature controller is in cooling mode
10
indicates the room temperature or the setpoint temperature
11
indicates the setpoint temperature or the room temperature
12
indicates whether the damper with an actuator is switched on or off
13
indicates fan speed selection 14
indicates operation of the temperature controller in heating mode
15
Fig. 2
Junction box Casing
Front panel
connection
Front
panel
5 www.ventilation-system.com