EN
10
Power supply 230 V/50 Hz
Non-regulated 230 V/2 A output
N
Neutral
Regulated motor output
CONNECTION TO POWER MAINS
• Install the inner part of the controller into the mounting box with the screws.
• Apply the mains voltage and switch on the controller.
• Adjust the minimum fan speed at the end position of the control knob.
• Turn of the controller.
• Wait for the fan to stop.
• Turn on the controller to the minimum speed, the fan should rotate steadily at the
minimum speed.
• Install the decorative cover.
• Put on the control knob.
• Unscrew the knob to the off position.
• If necessary, drill a 5 mm hole for condensation water outlet at the base in case of
wall mounting.
• The system is ready for operation.
