SERVICE
Service - 21
9. Clean up any spilled oil and dispose of oil in
accordance with local laws.
10.
CAUTION
Oil is hazardous to the environment. Drain oil into
an approved container and dispose of used oil in
accordance with local laws.
Proceed to the Changing Hydraulic Oil Filter
section for filter replacement instructions.
Changing Hydraulic Oil Filter
1. Detach the loader from the power unit.
2.
Place a drain pan beneath the filter area to catch
any oil leakage.
3.
Remove the filter (A) from the loader.
4.
A
Wipe the filter mounting surface with a clean
cloth.
5.
Apply a thin film of clean oil to the gasket on the
new filter.
6.
Install the new filter. NOTE: turn the filter clock
-
wise until the filter gasket makes contact with
the mounting surface. Tighten 1/2 - 3/4 turn after
gasket contact.
Lubrication Locations
Lubrication is required at the following locations
using a lithium complex NLGI #2 grease. Refer to
the maintenance schedule for service intervals and
amount of grease.
Raise the loader arms and engage the cylinder lock
stops. Tilt the tool attachment mount forward to access
the grease fittings at the tool attachment mount. Wipe
the grease fittings clean before applying grease.
Reference A = Cylinder End (8 places)
Reference B = Loader Arm Pivot (4 places)
A
B
B
B
A
B
A
A
Содержание KH500 Versa-Loader
Страница 25: ...Specifications 25 Blank Page ...
Страница 32: ...PARTS Illustrated Parts 32 Use only original Ventrac replacement parts ILLUSTRATED DRAWING Hydraulic Lift ...
Страница 34: ...PARTS Illustrated Parts 34 Use only original Ventrac replacement parts ILLUSTRATED DRAWING Hydraulic Tilt ...
Страница 38: ...PARTS Illustrated Parts 38 Use only original Ventrac replacement parts ILLUSTRATED DRAWING Hydraulic Diagram ...
