Ventrac KH500 Versa-Loader, Руководство оператора и чертежи запасных частей

Страница: 15 / 41

Operation - 15
OPERATIONAL CONTROLS
Joystick Control Valve
A
The joystick control valve (A) controls the functions
of the loader.
1
2
3 4
1. Pull back on the
joystick to raise
the loader.
2. Push the joystick
forward to lower
the loader.
3. Move the joystick
to the left to dump
the bucket.
4. Move the joystick
to the right to roll
back the bucket.
The loader arms can
be allowed to float by
pushing the joystick
forward until it locks
in place. This will
allow the bucket to
float on a hard work -
ing surface to reduce
the amount of wear on the bucket and cutting edge.
The float function can also be used help prevent
mixing of surface material with stockpile material
by reducing the chance of surface gouging when
removing material.
Bucket Level Indicator
The loader is equipped with
B
a level indicator rod (B) that
shows when the bucket is
approximately level when
resting on the ground and not
easily visible. The bucket is at a
level position when the end of
the indicator rod is visible in the
angled end of the indicator tube.
Tool Bar Locking Lever
C
The tool bar locking lever (C) engages and disen-
gages the pins that lock the tool to the tool attach-
ment mount.
Move the locking lever to the right to engage the
locking pins. The pins must extend through the
holes in the sides of the tool frame.
Move the locking lever to the left to disengage the
locking pins when attaching or detaching a tool.
Cylinder Stop Prop
D
Disengaged
D
Engaged
The cylinder stop props (D) can be lowered to prop
the loader arms in a partially raised position. The cyl-
inder stop props must be engaged prior to detaching
the loader from the power unit, in order for the loader
to stay properly positioned for reattachment.
If maintenance or repairs cannot be performed with
the loader completely lowered, engaging the cylin-
der prop stops will lock the loader arms to prevent
them from lowering while service is performed.