#2 Chootoo Road, South Aranguez, San Juan, Trinidad
EPD61 SERIES
HB0120
INTENDED FOR DOMESTIC COOKING ONLY
INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.
HOMEOWNER: USE AND CARE INFORMATION ON PAGES 9
AND
10.
READ AND SAVE THESE INSTRUCTIONS
Broan-NuTone LLC; Hartford, Wisconsin www.broan.com 800-558-1711
Venmar Ventilation ULC; Drummondville, Québec www.broan.ca 877-896-1119
REGISTER YOUR PRODUCT ONLINE AT: www.broan.com/register
SV20571 rev. 06
INSTALLATION INSTRUCTIONS
S
UITABLE
FOR
USE
IN
DAMP
LOCATIONS
WHEN
INSTALLED
IN
A
GFCI PROTECTED BRANCH-CIRCUIT.
I
NTENDED
FOR
OUTDOOR
COVERED
PATIO
OR
LANAI
AREA
.
!
!
2
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
1.
Use this unit only in the manner intended by the
manufacturer. If you have questions, contact
the manufacturer at the address or telephone
number listed in the warranty.
2.
Before servicing or cleaning unit, switch
power off at service panel and lock service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be locked,
securely fasten a prominent warning device,
such as a tag, to the service panel.
3.
Installation work and electrical wiring must be
done by qualified personnel in accordance with
all applicable codes and standards, including
fire-rated construction codes and standards.
4.
Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
backdrafting. Follow the heating equipment
manufacturer’s guidelines and safety standards
such as those published by the National
Fire Protection Association (NFPA) and the
American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE) and
the local code authorities.
5.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
6.
Ducted fans must always be vented to the outdoors.
7.
Do not use this unit with any additional
solid-state speed control device.
8.
To reduce the risk of fire, use only metal
ductwork.
9.
This unit must be grounded and protected by a
GFCI.
10.
Suitable for use in damp locations only when
installed in a GFCI PROTECTED branch-circuit.
11.
This unit is not designed to be used with a
charcoal grill.
12.
When applicable local regulations comprise
more restrictive installation and/or certification
requirements, the aforementioned requirements
prevail on those of this document and the installer
agrees to conform to these at his own expense.
TO REDUCE THE RISK OF A RANGE TOP
GREASE FIRE:
a)
Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
b)
Always turn hood ON when cooking at high heat
or when flambeing food (i.e.: Crêpes Suzette,
Cherries Jubilee, Peppercorn Beef Flambé).
c)
Clean ventilating fans frequently. Grease should
not be allowed to accumulate on fan, filters or in
exhaust ducts.
d)
Use proper pan size. Always use cookware
appropriate for the size of the surface element.
1.
For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.
2.
To avoid motor bearing damage and noisy and/
or unbalanced impellers, keep drywall spray,
construction dust, etc. off power unit.
3.
Your hood motor has a thermal overload
which will automatically shut off the motor if
it becomes overheated. The motor will restart
when it cools down. If the motor continues to
shut off and restart, have the hood serviced.
4.
For best capture of cooking impurities, the
bottom of the hood must be located at a minimum
distance of 36” above cooking surface.
5.
Two installers are recommended because of
the large size and weight of this hood.
6.
To reduce the risk of fire and to properly
exhaust air, be sure to duct air outside — Do
not exhaust air into spaces within walls or
ceiling or into attics, crawl space or garage.
7.
This product is equipped with a thermostat
which may start blower automatically. To reduce
the risk of injury and to prevent power from
being switched on accidentally, switch power off
at service panel and lock or tag service panel.
8.
Please read specification label on product for
further information and requirements.
WARNING
CAUTION
TO REDUCE THE RISK OF INJURY TO
PERSONS IN THE EVENT OF A RANGE TOP
GREASE FIRE, OBSERVE THE FOLLOWING*:
1.
SMOTHER FLAMES with a close-fitting
lid, cookie sheet or metal tray, then turn off
the burner. BE CAREFUL TO PREVENT
BURNS. IF THE FLAMES DO NOT GO OUT
IMMEDIATELY, EVACUATE AND CALL THE
FIRE DEPARTMENT.
2.
NEVER PICK UP A FLAMING PAN — You may
be burned.
3.
DO NOT USE WATER, including wet dishcloths
or towels — This could cause a violent steam
explosion.
4.
Use an extinguisher ONLY if:
A.
You own a Class ABC extinguisher and you
know how to operate it.
B.
The fire is small and contained in the area
where it started.
C.
The fire department has been called.
D.
You can fight the fire with your back to an exit.
* Based on “Kitchen Fire Safety Tips” published by
NFPA.
WARNING
!
!
3
- EPD61 SERIES RANGE HOOD SYSTEM -
M
ODEL
437
(H
IGH
CAPACITY
ROOF
CAP
)
HL0186
M
ODEL
441
(10’’
ROUND
WALL
CAP
)
M
ODEL
418
(10”
ROUND
ADJUSTABLE
ELBOW
,
OPTIONAL
)
OPTIONAL
WALL EXTENSION
AWEPD SERIES
D
UAL
B
LOWER
(
INCLUDED
)
EPD61 SERIES
RANGE HOOD
10”
ROUND
ADAPTER
(
INCLUDED
)
M
ODEL
410
(10”
ROUND
DUCT
— 2
FT
.
SECTIONS
)
OPTIONAL
DECORATIVE FLUE
AEEPD SERIES
4
1. INSTALL DUCTWORK AND ELECTRICAL WIRING
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most
efficiently.
Install proper-sized ductwork, elbows and roof or wall cap.
Connect metal ductwork to cap and work back towards the
hood location. Use 2” metal foil duct tape to seal duct joints.
Run 3-wire power supply cable to installation location.
For best capture of cooking impurities, the bottom of
the hood must be located at a minimum distance of 36”
above cooking surface.
18"
W
ALL
CAP
36"
MINIMUM
ABOVE
COOKING
SURFACE
16"
TO
TOP
OF
WOOD
MOUNTING
STRIP
O
PTIONAL
DECORATIVE
FLUE
OR
SOFFIT
HH0182A
R
OOF
CAP
10" R
OUND
DUCT
10" R
OUND
ELBOW
10" R
OUND
ADAPTER
CAUTION
This range hood is intended for outdoor covered patio or lanai area. As with all electric
appliances, this unit must be protected from the effects of weather.
WARNING
!
This range hood is not designed for use with a charcoal grill.
WARNING
!
The power cable must be a GFCI protected
branch circuit.
2. PREPARE INSTALLATION
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or
damaged, contact the manufacturer.
Make sure that the following items are included:
-
Range
hood
- Wood strip (attached to back of hood)
-
Installation
manual
-
Accessories
including:
• Baffle filter with handles: 3 for 36” width model, 4 for 42” and 48” width models
and 5 for 60” width model
• 10” round adapter (taped inside the hood)
• Bag of parts: 3 waterproof wire connectors, 2 no. 8 x 5/8’’ screws, 6 no. 10 x 2’’ hex head screws,
4 no. 10 x 2” flat head screws, 2 wall anchors, 2 washers 3/16’’ ID x 3/4’’ OD
Included in parts bag, but not to be used (please discard): 2 wire clamps LP16-AP,
2 no. 8 x 3/8’’ zinc-plated screws, 8 no. 8 x 3/8’’ stainless steel screws,
4 stainless steel 10-32 locknuts, 4 washers 3/16’’ ID x 3/4’’ OD
WARNING
!
When performing installation, servicing or cleaning the unit, it is recommended to
wear safety glasses and gloves.
BROAN - EPD61 SERIES - RANGE HOODS
INSTALLATION GUIDE
