1
2
3
4
5
6
CUT EXISTING CONNECTOR
FROM BATTERY.
NOTE: CUT ONE
WIRE AT A TIME TO PREVENT
SHORTING THE BATTERY.
REMOVE INSULATION
(1/8in or 4mm)
REMOVE 1/8" (4mm) OF
INSULATION FROM END
OF WIRE WITH WIRE
STRIPPERS.
PLACE PLUG ONTO
THE WIRES
NOTE: MAKE SURE
POLARITY IS
CORRECT.
USING A SOLDERING IRON
SOLDER TERMINAL TO WIRE END.
APPLY
HEAT
PULL PLUG TOWARD THE
SOLDERED TERMINALS
UNTIL THE TERMINALS
HAVE SNAPPED INTO
THEIR PROVIDED
SLOTS.
1
2
© Copyright 2012 Venom Group International
Actual product may vary from product shown. Product is subject to change.
NOTE: MAKE SURE TWO
ENDS DO NOT TOUCH.
YOU RISK SHORTING
OUT THE BATTERY
.
HOLD WIRE DOWN
TO TERMINAL WITH
THE "O" SIDE UP.
DO NOT SOLDERING PAST
TERMINAL BARBS!
NOTE: TOUCH SOLDERING TO END
OF HEATED WIRE, NOT THE IRON.
SOLDER
ASSEMBLED PLUG
1645-2
PATENT PENDING
