Required Tools
measuring
tape
drill with
2mm bit
phillips bit or
screwdriver
pencil
knife
How to install your
#37103-64500-B
Shutters with Reveal Frame
Difficulty:
Included Hardware
The hardware can be found in
the small hardware box included
with your blind.
1
1
Getting Started
2
Assemble the Frame
1
Make sure ITEM# (Highlighted in the circle) matches on both panel boxes.
Do not dispose of packaging until the shutters are operating appropriately.
Use of a moving blanket or drop cloth is recommended.
Find ample working space to assemble your frame (preferably in front of the window).
Check the diagram to make sure you have all the parts indicated for an appropriate
installation.
Carefully remove panels and frames
from the packaging.
Do not mix panels or frames from other
windows. All frame pieces are labeled
(top, bottom, right, left).
Dovetail Key
Hinge
Pins
Short
Screws
(For Hinge
Installation)
Plug
Hinge Spacer
Long
Screws
(For Frame
Installation)
The top and bottom of the T-post are labeled. Locate and identify. Line up the pre-drilled
holes with the top and bottom frame and secure with screws provided. Fasten the T-post
with additional nails if necessary.
※
If not installing with T-POST, skip to #4.
The T-post connector provides
some wiggle room, make sure the
T-post is at the center position at
each end and secure with two
screws. The T-post can also be
adjusted when gaps between
panels are not even.
Set all frames on a soft, level surface (moving blankets or some type of pad works best).
Position each side of the frame and line up the Dovetail Key slot.
1
2
3
Medium
Screws
(For T-post
Installation)
Shutters with Reveal Frame
How to install your
#37103-64500-B
Difficulty:
2
The frame is pre-drilled well in the top left and right frame, bottom
left and right frame, and in the middle of the top and bottom
frame. Double check that all the holes are pre-drilled before
placing the frame on the window.
4
Position the assembled frame evenly along the window opening against the window. by using a tape measure and shims.
5
Once you have evenly spaced the frame into the window
opening, secure with a screw (pre-drill) into the upper left frame
ONLY. Shutter will be fully secured in later steps.
Once done, level the frame on the window.
6
Measure left & top frame for spacing
Measure right & top frame for spacing
Only secure one screw into the top left frame.
Once the left side is secured, to keep the frame level and secure with a screw (pre-drill) into upper right frame. Shutter will be
fully secured in later steps.
7
8
Level the top frame.
Only secure one screw into the top right frame.
With the rounded side of the Dovetail Key facing up,
push the top frame down onto the Dovetail Key.
The Dovetail Key has a rounded side and a flat side.
The rounded side should be inserted in slot first.
!
Insert the Dovetail Key into each slot at the back of the frame. Use a rubber mallet if necessary.
1
2
3
4